Ok ... If I understand this correctly the facing cutters cut the face of the die (a square cut)
which deals with the change of the the cut. It did not come with these.
The forcing cutters is comes with two ... the 11° and the 18° .. its came with two of these.
FrontSite
For sale is a .32 Cal (only) chamferring Tool. Its complete but does not
have the .22 cal rods. Price $90 shipped to lower 48. This is a new
one I bought from Brownells 4-5 yrs ago.. It has been used.
The paper photo is included but not pictured
FrontSite
I usually wait till I have a large order but last week I "just had to have" an AR-15
spring kit.. $10.49.
They added a "special handling fee" of $3.00
then added shipping at $4.12.
This was all shipped in an 10*13 padded bag. Whats the special handling fee?
Maybe because its so small it...
JR5... Don't get me wrong .. you can shoot cast in the .327 .. just maybe not that cast
It may shoot fine in the .327 but at a slower than optimal speed for that cal.
The Penn bullets I shoot in the 32 mag are rated at 1600 fps max and I have shot some
at close to 1400 with no leading issues...
JR5,
Hey a fellow Buckeye?
I had bought some of those bullets from Vance years ago and I think they were marked "Patriot Bullets" on the box. The ones I had were for .45 cal so I was shooting them a lot slower with some Universal powder but with my Lee Hardness tester they tested abt 11.8 BHN...
Depends on how hard the lead is....
But I would only use 231 with softer lead ..
My guess would be to use a slower burning powder (H110) with a hard lead bullet
especially in that caliber.. a hot one !
I don't load the .327 but I do load the .32mag and 10.2 gr of H-110 with a 95 gr
hard (18...
I've tried just shooting it before with other tight throated revolvers and
always got really bad leading in the cyl and around the cyl gap.
All five of my other 32's are fine after opening up the throats.
All I shoot is lead and these throats meas from .310 - .311 Like a lot of
the other 32's...
I got the E model a few months ago and have close to 200 rnds now.. mostly handloads with some Fed & Win factory all shot on setting 2. I tried setting 1 and it failed to feed. Handloads are FMJ 55g Horn with a full case of Varget. 100yds from the bench with a 10rd mag all hit within 1.5" but...
Finally picked up a SSM-4 to complete my collection of shooters but like
the others it has tight throats. CAS tells me he no longer does these so..
anybody reaming the 32's or does someone have one to sell or pass on ??
Thanks, FrontSite
I bought mine when they first came out for $74 along with more $ for all the attachments from Midway. The only press I've used.. not sure on the round count but must be over 10K.. .357 - .45 Colt - 45 ACP - 32 Mag - .223 - 30/30 - .380 - .38 spl. I really like the primer setup and have had no...