Recent content by hhilljr

Good comments, I appreciate the suggestions. I have removed all the trigger guard components to eliminate any interference from them. The fit didn't change, so I'm OK there. There was a burr in the trigger spring plunger hole which I removed, and I have gently tried to smooth up the frame where...

I have used a plastic tipped gunsmith hammer with pretty hard whacks. I’ve been tempted to clamp it in a padded vise, but I’m not to that point yet.

Hello I’m having a very difficult time reassembling my GP100 10mm. I cannot get the trigger guard to fully latch back into the frame. I’ve smoothed out a few rough edges and removed a burr or two, but there is still a hairline gap towards the rear of the trigger guard. I can pull it back out...

My Single 7 purchased this year had XRP machined into the grip panels. I ordered a set of Eagle grips for it, which fit very poorly when I received them. We had several conversations about the situation, and I'm not bashing their customer service or products. They made a new set which did fit...

I feel your pain! I've fought that part several times. I have no tricks to offer, but to say that persistence will eventually pay off.

Very nice Ruger! I have a 5.5" version, and would like to upgrade the ejector rod too. Could you share where you were able to find one? Thanks

Thanks for the info. I had suspected that SSM might stand for Single Six Magnum, so for once, I guessed right. Thanks again.

Hello all: I have been looking at 32 H&R revolvers lately, and have seen Single Six SSMs available. I've not heard of this model, and was wondering what was different from a regular Single Six, other than the 32 Mag caliber. Thanks!