Recent content by Moey

Well my little 32 is shooting really high. I would hate to replace the fiber optic but I am out of adjustment and six inches high. Help

So there are different sizes now? Can someone explain please.

Shoots like crazy. Extracts poorly on 2 chambers, even with reduced loads. Not being super knowledgeable, and not having had this issue with any other revolver. What would most likely be the cause. Also have to trim the brass a fair amount after each loading. Both Starline and Fed. Thanks for...

All SS, 1 5.5, 1 7.5 in 41's. Didn't ask on the 357's but they have consecutive serial numbers too.

Found a guy with 4 1984 Redhawks, NIB, never fired. two 41's and two 357's. Wants 1200 each.

Mostly I didn't like the 10 shots! Had cylinder issues, meaning lots of different ammo was hard to extract on several chambers. Wasn't as accurate as I was used to. The sights were awesome though. Put a set on my 17 HMR. I can see!!

Gun show in town this weekend...Giddyup!

I have one, 6.5, it's fun, fairly accurate, LOUD, no recoil, best of all it's a 6 shot. Have a 14" TC Contender with a Burris rifle scope. It is lights out accurate. Only shoot Hornady's out of them both.

I hated my S Ten

Now I want a pair!

I was out with it again yesterday , maybe fired 100 rounds thru it. I love it. Sights are hard to see with old eyes but from a rest it was quite accurate. Maybe 2.5 inch at 15 yards. Had a single 10 and hated it. It cost $600! the S10 had sticky chambers, fit and finish was poor, had 2 blue...

Wrangler...of coarse

Well I went to the local Cal- Ranch store yesterday to look at/buy a Ruger Charger that they have and ended up getting a Wrangler instead. Shot it yesterday also, I think it will be fine as long as I can see the sights. I really like the balance of it, the free wheeling, 6 shot, and the basic...

Thanks all! Will try the Unique loads next time

Thanks all for the replys. Velocity goal would be about 1000-1050. I'm more concerned with recoil for her. I will try and start out with mid range 38 loads and see what happens. Can I use standard primers and/or mag?