Recent content by Mr. Boom

If you are so inclined to do likewise, i slightly bent out the leg on the spring for the safety on mine. It felt a bit too light also, but that little adjustment worked!

I'm right there with ya! I put the SA kit in mine and fell in love with it all over again. Parts were well made and fit perfectly.

Mine have kind of a brushed finish.

I just got a new one today that is made in USA. It drops free and works perfectly! After i removed the axle grease from it! :)

Perfectly stated. Thank you

Rev. Back off. Stand down. I asked a simple damn question. I did not want a tirade on the virtues of high dollar guns. I have a SR9c. The striker spring is noticeably lighter than the one in my older SR9.

I may go that route with the Ghost reset bar. I understand about light strikes, however, i think it could benefit from a spring from a 9c. I hear you about modifying.

Just so we are clear here, children, i want to know if newer version striker springs are lighter/different/heavier than the one that is in my '09 SR9. Might lighten the pull a bit if it is lighter, as mine is pretty heavy.

Third time to the range with my SR9, and this is the result, at ten yards, standing. The group around the one inch orange dot is one full mag. So i would say the accuracy is there.

Well i loaded up 10 each of 4.5gr and 4.8 gr Win 231 under the Xtreme 115gr, and they all ran perfect. The 4.8gr ejected a little farther out, but the 4.5 gr still ran100% Time to load up a couple mags worth of each and take those out. FWIW, after running another 100 Armscor 124gr...

Anyone with an SR9 or SR9c change out their striker spring with the Galloway version? How much heavier is it, or is it heavier? Not sure if the SR40/c uses the same striker or not.

That's what i am hoping to get to after a few hundred rounds also. Thanks!

Thanks. AFter doing some reading, i am gonna try 4.5gr and work up to 4.8gr and see what works best.

Took my new SR9 out yesterday after a thorough cleaning. Factory ammo ran great. My reloads not so much. THey are a bit light. Wasn't sure they would run at all. I use 4.2 gr of Win 231 under Xtreme 115 gr plated. These run fine in my smaller frame 9mm guns, but the SR9 didn't like...

Well, i had an SR9c, and loved that trigger. I did notice that the reset bar in the SR9 is a bit different from the 9c. I had an extra, so i put it in while i was cleaning the Jurassic junk out from the factory. So mine has been good from the get go. No complaints here.