Recent content by rob-c

Yep I would ..

I had thought about going up on the trigger spring , It has a 30oz in it now and I have a 40oz to put in . I actually Installed a 24 pound extra power hammer spring thinking the occasional light strike may have been that so it’s not stock weight . I’m not 100% sure the pull weight is correct...

So I bought this 357 mag used some years ago and I hunted with it and killed a few deer for a bit. I moved up to my SRH 44 so I passed this down to my son . About 5-6 years ago I did a complete dis-assemble of the revolver and it was pretty nasty . At this time I polished the trigger hammer...

Times 2 , I’ve used non chlorinated on min and wife’s lcr’s zero problems.

I have hogue Pau Ferro non checkered on my SRH and like them a lot . Not sure if this what you want exactly but here’s some in checkered https://www.hogueinc.com/grips/ruger-grips/gp100/exotic-hardwoods/pauferro/gp100-super-redhawk-pau-ferro-no-finger-groove-checkered There’s other styles you...

Yeah , not for me either. I know awhile ago it almost shut down and some of the members bought the sight.

Yep they are, I used this when I ran my 30mm ultra dot red dot. It gave me more adjustment for the placement of the sight tube .

Something to consider that I didn’t see mentioned is width, a smaller s/s will get you on a lot more trails and snake through the woods easier.

Weigand weig-a-tinny is for 44 mag only $40tyd Hogue grip was installed tried and removed $20tyd Pm me and I’ll text or email photos . I have these listed else where also ..

I was using a 180 grain rim rock hard cast gas check for hunting, it’s the same bullet that buffalo bore uses in their heavy hunting loads . So with 13 grains of 2400 with a heavy crimp I was getting mid 1300’s over the chronograph. I was close enough to their 1400’ FPS to be happy with it...

Just a tip . if you suspect a hub is going but not 100% sure, jack up that side of the vehicle place a hand on you’re coil spring and spin the wheel you’ll feel the rumble in the spring. Myself if I’m at high milage and doing wheel bearing, ball joint etc. I always do both sides. Because as...

If you can let it sit spray with kroil it works great, I used it when I did my plugs in my 5.4 triton you know the ones that break off. Spray it let it sit over night and give it a 1/2 1/4 turn spray again let it sit and do 1/2 turn again. If it still seems to be hard I would warm the engine...

Hogue sells a rubber non finger groove grip, I bought one for my SRH because my big fat fingers did not fit in the finger grooved one. Didn’t like that one either and bought a non finger groove wood grip from hogue. It had a way larger palm swell that fits my hand great.

I bought a used Blackhawk, and decided to disassemble for a deep clean and was shocked how much crud was in there. After cleaning it actually smoothed out the gun.

I moved mine into my sons old bedroom, not because of the heat in NY , but the winters when there is nothing to do, I can reload till my hearts content . And my 44 and 357’s get a steady diet of 2400..