Recent content by Yellowhouse

Its in 260 Remington and like new. Are these in this caliber scarce?

Pachmayr rubber grips for three screw Blackhawk. Message me availability and price please.

Did you have to modify your front sight height? And to everyone else....is there any chance Ruger might make this a regular production item?

Just installed one of these but the directions didn't really address the sear engagement. Have adjusted lots of Remingtons but not a ruger. I ran the screw in till the firing pin fell and then backed it out a half turn and tested pull at 2.25 lbs. Trigger spring tension had no real effect in...

Hmmm! The trigger in my M77 .243 works like a dream and now this. Said above this was my first & had forgotten about it. Anyway, still trying to find some info on the stock trigger. Did you have to remove any wood to install the Timney?

Tang safety model made in year 1990 (prefix 772). Trigger breaks at 5.5 lbs when turned in to where about it requires 2 full turns brings it to surface. At surface level its 5 lbs. When I backed it out to where three threads show there was no change and finally backed it out to near 4-5 threads...

Tang safety model made in year 1990 (prefix 772). Trigger breaks at 5.5 lbs when turned in to where about it requires 2 full turns brings it to surface. At surface level its 5 lbs. When I backed it out to where three threads show there was no change and finally backed it out to near 4-5 threads...