Help Support Ruger Forum:
-
-
Kkmoore replied to the thread Ruger Mini-30 with 185 serial number.The first several years of production of mini-14s, they had wooden upper handguards not plastic like in the photo. I don't know what...
-
Kkmoore replied to the thread Sp101 4 in..You might look for a pocket gun to carry in a pocket. Thats not a pocket gun. Even a J frame S&W round butt with 2 inch fits in my front...
-
Kkmoore replied to the thread Mounting the Picatinny or Weaver Rail (To Locktite, YES).Normally a correct torque using a gauge works wonders. I did use a bit of blue on my 338 RUM and 375 H&H mag. Just because I don't want...
-
Kkmoore reacted to Mylo1899's post in the thread Mounting the Picatinny or Weaver Rail (To Locktite, YES) with
Like.
Yep, that works too. My point in writing the post was just to mention the fact that blue Loctite works fine if it’s applied correctly... -
KThere is a 52 grain 5.56x45 NATO load, it's called M995. It's a black tip AP round. It was probably from the days when the M16's had a...
-
Kkmoore replied to the thread Mini-14 ammo.Ok, I did not think of that bullet. Sorry Wayno. I was thinking of the standard 55gr FMJ.
-
KAlways go by what a loading manual says. A lesser charge in a larger case can be as bad as exceeding maximum loads.
-
Kkmoore replied to the thread Mini-14 ammo.Going with what the poster printed that the manual said. "Standardized US military or factory loaded sporting .223." Ok what the heck...
-
Kkmoore replied to the thread What is your minimum comfort zone for brass stock?.I don't move it around. Just open and scoop out.
-
Kkmoore reacted to Enigma's post in the thread What is your minimum comfort zone for brass stock? with Like.
How much does that mortar can weigh, once it's full? Might be a real chore if you have to move it!
-
Kkmoore reacted to DRAM40A1's post in the thread What is your minimum comfort zone for brass stock? with Like.
I just keep buying it. My wife asks, did you need more of that. My answer, what’s need have to do with it?!!!!😆
-
Kkmoore replied to the thread What is your minimum comfort zone for brass stock?.I found out a mortar can will hold about 8,000 5.56 cases. 9mm, 40 S&W, 45 acp a 50 cal ammo can full is enough. About 12 other calibers...
-
Kkmoore reacted to Enigma's post in the thread What is your minimum comfort zone for brass stock? with Like.
I pretty much share the OP's mindset. I just finished trimming the last of my .475 Linebaugh brass to .480 length last night. I hope...
-
Kkmoore replied to the thread SOLD RCBS rifle die set.Sold pending funds.
-
KRCBS G group dies, this was a custom order set. Unknown if they still have these available. 3030 Ackley Improved with upgraded Hornady...
-
-
-
Loading…
-
Loading…
-
Loading…
