I've got an OMSS lightweight (tri) that I bought converted but it came with the original parts kit. I've installed the old parts, no problem. But then I realized the base pin in the old parts kit is a larger diameter and will not fit through the cylinder. It goes into the frame just fine but not into the cylinder. I test fit it directly and it's too large a diameter for the cylinder.
My question is, is it ok to use the converted base pin with the plunger on the end or will that bind or cause problems?
Thanks!
TomD
My question is, is it ok to use the converted base pin with the plunger on the end or will that bind or cause problems?
Thanks!
TomD